remote start will only work when key is next to barrel ?

Question

toyota 2010 rav 4       evo one with out t harness    basically the evo one is not emulating the transponder     please help is ther anything i can do to fix this or do i need to buy a evo key module to emulate the immoblizer

 

everything work just fine but remote start will not start the car   it will just crank ....unless i put the key nest to the barrel then it will start

Answer 1

On your key is their a G stamped on it or a dot? I need this information to give you accurate information for troubleshooting.

 

Also are you using a grey or black key to program?

Comments

The key has a dot on it and I’m using a black key with buttons for unlock and lock

---

Is this the guide you have been following?

http://cdn.fortin.ca/download/58481/evo-one_ig_reg_bi_toy-old_key_2_b_58481.pdf

 

Does the bypass program properly?

 

Also you forgot to set up option 20.2 in the starter.

---

No I followed the guide for a g key

 

and when I program the module it recognizes when I hit lock and unlock. the blue lights flash

 

what is option 20.2

---

The guide for G key will work for can bus, but will not work for immo bypass. You need to wire in the evo as shown in the above guide for the transponder portion. Rx/Tx and Key sense.

---

Ok I will try that tonight when I get home. And change to option 20.2 Thank you for your help

---

So i wried it the correct way and programmed it but i guess it woont work with the oem key fob?    

If so what do i need to buy to make it work

---

Techinically its not supported on that vehicle but you can try to leave the can bus wires connected and try following the programming on page 4 of this guide to see if it will work.

http://cdn.fortin.ca/download/72301/evo-one_ig_reg_bi_toy_tundra_2007-2010_key_a_72301.pdf

---

It works now      Thank you for help