location of IMO wire in australian spec sti my17

Question

I'm doing a australian delivered my17 subaru sti (push-to-start) and I don't seem to have a wire in the location discribed for the Immobilizer, pin 25 red/white wire. I was hoping someone had another location to pick this up? Would this affect the firmware aswell ? Everything else on the diagram is present.

Answer 1

Is your WRX STI Push-to-Start or Key Start?

Comments

sorry the vehicle is push-to-start

---

The pin is empty or is there a red/white or green/black in pin 25?

---

yes pin is empty. Would a picture of the 35 pin plug showing the pins populated etc be helpfull? If so is there an email address to direct it to.

---

support@fortin.ca

 

connector should look like this http://image-3.wirecolor.com/vehiclegroupimage/127741.jpg

---

if not present, you might need to go to the ECU under the hood.

green/black , pin 43 of a 48 pin connector

ECU has 3 connectors. Should be in the first connector.

 

Make sure the light blue / black wire from the evo goes to the ECU side of the immo wire after cutting it.

---

I'm pretty sure the sti model doesn't have a ecu under the bonnet. Does anyone have any other listing or idea to figure out where i would beable to locate the Imobiliser wire?

---

What is the complete VIN to the vheicle?

---

Vin is -----------