Rapid security blink after two key programming 2010 f150

Question

Can bus programming passed. After two key programming, the security light flashes and ignition stays on. Programming doesn't complete. Tried multiple times programming from the beginning. Still no success in finishing this install after two days. Also tried the decryptor way with no luck.

Answer 1

How are you installing the evo-all?

Looking at the options the module is configured in a way that would make it not work.

What happens with the lights on the evo-all when you press the programming button at the end of key two?

Comments

It says red. What options should the unit be set to as a stand alone remote start? I've tried different configurations, but nothing has worked yet.

---

At this point your best bet would be to do a master reset as indicated here:http://wirecolor.com/en/qa/50193/faq-how-do-i-reset-my-evo-all?show=50193#q50193

Then leave all options as they are and only turn on options C1 and D1

Then program the module in the vehicle.

Don't forget we are just a call away if you need some help. Give us a shout when your in the vehicle and we can figure out what's going on with you Toll Free: 1-877-336-7797

---

Customer called in...vehicle bcm was locked......Followed DCryptor programming with customer.

Car fired right up!! :)

---

Thanks again Derek!!! Very helpful! Definitely recommend this product to anyone!!

---

No problemo!!! Always happy to help!