EVO-ALL TOYOTA VENZA 2010 PTS Not remote start.

Question

Hello!

EVO-ALL TOYOTA VENZA 2010 PTS

I did everything according to the guide # 8611, block programmed. Then, when I press the "lock" button 3 times on the key, the ignition turns on but the car will not start. Starter does not turn. 

What could be wrong? 

Where to connect the wire yellow / black (A13)?

Regards, Konstantin.

Answer 1

The yellow/black does not connect anywhere and is not required for remote starting. It only acts as a switch to activate the remote starter.

 

What firmware do you currently have? Have you update the EVO to the latest Toyota/Lexus firmware?

Comments

Problem solved ! Was poor contact white / red

wire ( D6 ) on the steering column lock . connected to

7 pin black connector on the left of the ignition button under the steering column . 4 pin violet wire (-). D5 wire white / blue connect to ground. Everything. EVO- AL works ! Thank you !

Answer 2

Hello,

I am writting here because I also have a 2010 Venza with PTS but I am not doing the stand alone install. I am also having problems remote starting but I have my own post here. I want to be aware of this solution just in case it may help me also. Thanks