Linker LT1 not starting vehicle

Question

Evo one, 2017 sonata reg key, oem and aftermarket remotes working, on the my car app it sees voltage and red and green lights are lit on LT1, I programmed the LT1 to module but it won't start vehicle

Answer 1

which remotes to you have programmed to the unit?

were you able to properly pair the linkr and evo-one? was option Fortin2 enabled?

Comments

AX RF1, I believe it paired as I received a red light at end of sequence, fortin2 is enabled in module, app only has option for fortin

---

On your antenna what is written? FM or FMH-2way?

---

fmh 2w, diode installed in harness also

---

Any troubleshooting for this?

---

try unplugging the my car then program the fortin remote, then plug it back in and try to program just the my car?

---

Remotes are axxess rf1,,,they are working....the lt1 pairs, fortin2 is enabled in evo one,,,only choice in my car app is fortin

Answer 2

Working, wiring was wrong

Comments

I have followed the LINKR-LT1 manual to the letter and it has been impossible to run my EVO-ONE with the LINKR-LT1. I have updated the firmware of the EVO-ONE to the latest version and configured the protocol to Fortin 2, I am also configuring the EVO-ONE with the valet buttom, what calls my attention is that when I am configuring the EVO-ONE according to the instructions the LED next to the main button starts flashing repeatedly and does not remain fixed as in the manual instructions. I would appreciate comments about some extra procedure to do troubleshooting. Could you please share the exact wiring that you are using which worked for you?

---

Rich, perhaps I am having the same wiring issues. Can you provide any insights on what the initial issue was and what your final wiring ended up looking like? Thanks!