EvoAll standard to standalone

Question

Hello

I have a EvoAll with a crimestopper LC1 remote module. I haven't installed it yet but I assume this system runs as a standard system and not standalone.

my car is a 2015 Focus se sedan 

I was wondering if is possible to disconnect  the lc1 from the evo all and configure it to run as a standalone only unit? If so, what settings need to be changed on evoall?

also, I see the following cables on the lc1 unit. Can I just disconnect them?

• ignition - out - goes to evoall key sense a1 and rs7 on thar-for1 (yellow/black)
• 12v - in
• Gnd when running - out - goes to a8 on evoall

thanks

 

Answer 1

The is the correct guide for standalone installation

http://fortin.ca/download/32051/evo-all_ig_tsa_bi_for1-focus_2012-2015-80bits_b_32051.pdf

It also shows what options need to be turned on.

Comments

Thanks so much!