Question

Please reset dcryptor limit on EVO One - sn 002B04 651595 .

 

Module programmed ok but when I pressed LOCK LOCK LOck the parking lights flashed three times and nothing else.It says the unit is not in ready mode.How do u put this module in ready mode.The Yellow loop is already cut for automatic transmission.I have tried reprogramming it several times to the same result.Would you think the module is bad and needs to be replaced?Any suggestions would be helpful.

Answer 1

Hello,

I have submitted your module for reset. It will be ready for use within 24 hours.

Couple suggestions, turn off A11 in the bypass. Also take a look under the yellow loop you cut, if the red led is on solid the unit is in valet mode. To disarm/enter/exit valet mode you can refer to this guide (page 6): https://cdn02.fortin.ca/download/69611/EVO-ONE_QG_RM942_EN_A_69611.pdf

Program it once start to finish, if it still wont remote start the vehicle give the tech line a ring and an agent can help you figure what is stopping the unit. Be sure to have the module and car on hand when calling.

1-877-336-7797

Mon - Fri

 8 am - 6 pm Est

 

Best regards.