2010 TOYOTA COROLLA CE

Question

HELLO, I SET UP EVO-ONE ON TOYOTA COROLLA  CE 2010 AND THE PROBLEM IS

1.THE IGNITION HARNESS THERES NO WHITE WIRE

2.BYPASS PROGRAMMING.2X PRESS AND RELEASE NOT WORKING,I NEED TO PRESS AGAIN AFTER I PLUG EVERYTHING THEN KEY TURN ON,THEN RED AND BLUE FLASH RAFIDLY THEN BLUE FLASH,THEN I TURN  OFF THE KEY,ITS LOOK LIKE PROGRAMMING IS OK

3.AFTER THAT REMOTE START WORK BUT IT WONT START JUST CRANK THEN I TRIED TO PLACE THE KEY NEAR THE CYLINDER AND ITS STARTS OK.

WHAT COULD BE WRONG? WHY ITS NEED THE ORIG KEY PLACED NEAR THE BARREL AND IT WILL START?,DO I NEED TO PUT THE ORIG KEY SOMEWHERE...WHAT IS THE SOLUTION PLEASE HELP...

 

THANKS..

Answer 1

Is it a regular key or g key??

also your options A1 to A11 should all be one as well as C1 and 38.2 id it is a G key and you are doing 3x lock to start.

Comments

It is listed as a 2010 as per your vin...it is a dot key...so non G-key...with that information the guide i previously linked is the correct guide for that vehicle...If it doesnt match up then maybe someone has changed parts out in the vehicle at some point and if thats the case i am not sure what you would need to do to install it...but according to all the information you gave me that is the correct guide previously linked....does it look like either of these pictures?

---

hello my friend,how are you,i tried everything but still doesnt work or start, but when i placed the key near the barrel or near the key hole engine start and ok, when i move away the key and remote start it again doesnt work again just cranking,it looks like the bypass is not working or maybe the key bypass is not working,what do you think could be the problem?...
and also the ignition harness is looks like the one on the buttom picture...
 

thanks

---

Try re programming the bypass module in the vehicle.

It looks like the bottom picture? That is the ignition plug from a 2010 corolla...

---

HELLO, YES THATS THE IGNITION PLUG,EXACTLY THESAME,WHAT IS THE PROPER WAY TO PROGRAM THE BYPASS, BECAUSE THE INSTRUCTION ON THE SET UP GUIDE IS NOT WORKING....

THANKS

---

The proper programming sequence is push and hold programming button, plug in datalink  cable, release on red, insert key (do not turn) red led should flash 10x, then remove key. done.

 

Thank you