Siren install

Question

Right now wiring is done per thar-one-toy16 harness i structions. I just ordered a siren and it says to connect the orange black wire to siren. Do i remove the orange black wire from the horn and reroute to the siren and connect black wire on siren to ground?? The aperntly horn doesnt chirp when remote start activates any way so im assuming orange black is reserved for alarm use??

Vehicle is 2023 tundra non hybrid

Answer 1

Orange/Black is a negative output, so it wires to the negative side of the siren.

Make sure to change option 12 to 12.4 in the remote starter settings as well so that the output is set for a siren (latched output) and not a horn (pulsed output).

Comments

Ok so siren pos gets a.fused connection to the battery???

Also manual has Siren(+) Output (E1) white Siren(+) Output (E1) white and Horn(-) as options but the vehicle specific harness is using the white whire.

---

White (e1) wire is being used to power the vehicle 2nd ignition for remote starting so it cannot be used as a +siren output. 

 

Ok so siren pos gets a.fused connection to the battery???

Correct, or a 12V supply in the fuse box