2018 camry H key

Question

Hello. I want to install evo-one (002B04138125) on 2018 camry (euro-H key). I made the firmware (099) and when I connect to the car, holding the program button, all three LEDs light up constantly and that's it. What to do? Last year I installed it on such a car and there was no problem.                                                                                   I upgraded to 0.67 .... Now when I turn on the ignition, the blue LED goes out.                                                                                                                                                                     In the manual that the firmware 88.15 is indicated, where can I find it in order to rewrite it into the module?

Answer 1

For north american camry (canada & usa) guide 69381 indicates firmware 79.66

 

For european camry guide 96581 indicates 88.15

 

Since your vehicle is not based in america or canada you should follow guide 96581 and use firmware 88.15 minimum.

Comments

Where is this 88.15? It is not in the manager. Maybe I'm doing the firmware by mistake? I first flash the bypass, and then the remote start. Thus, I have been flashing evo-one for the 7th year already.                                                                                           The corresponding firmware is written there __0.99 ---- 0.67 ---- 0.25 ---- 0.20. But 88.15 I have not found.

---

Try selecting a 2021 toyota rav 4 h-key, that should allow you to access the 88.xx firmware.

---

!!! Everything is okay. Thank you very much. When you have 12 noon, we have 21 in the evening and I have to work at night ... I did not sleep normally for 3 days. Thank you very much again. Can I connect the pink wire to the parking lights?                           I have already connected the pink wire on the rear parking lights via an additional relay. (black thin wire in the connectors of the lower keyboard).

---

Yes, pink is negative parking lights out.

---

I found the best option for a parking light. Under the steering wheel in a white connector, mode 14th (5th on the side) yellow wire. The remaining wire, the edge of the connector, is connected to 87a with the contact of an additional relay. The second half (the edge of the car) is connected to the 30th contact of the auxiliary relay. Connect the 16th (3rd from the side) green wire to the 87th contact of the additional relay. + for the relay we take to the left from the fuses, from the light brown wire. And, the pink wire turns on this relay. By the way ... why is the "optional" orange-black wire connected to the signal?