Evo-NIST1 on Honda?

Question

Hello,

i bought an EVO-NIST1 kit that was pre-programmed for the Nissan with the key port / push to start, and i used it for few months then I decided to sell the car. What do i need to make it work on the Honda Pilot 2013?

i know i need the T Harness for sure,  but can i program the Evo for the Honda?

thanks,

Answer 1

Their is no t-harness for the evo-all for that vehicle.

You would be best to get an evo-one and the thar-one-hon5 harness. This would be the guide using the evo one and harness:

http://cdn.fortin.ca/download/59551/evo-one_ig_thr_bi_hon5-pilot_2009-2014_key_a_59551.pdf

 

 

If you wanted to re use the evo you would need the following:

1- Flash link updater to flash and configure it for the honda.

2- complete wiring harness which will get manually spliced into the vehicles factory wiring.

3- high current remote starter of your choice.

Comments

So if i get evo-one and thar-one-hon5, do i need the flash link updater or its a plug and play?

---

you would still need the flash link to configure it for that specific vehicle the way you want.

---

Okay thanks!